Tweet
The cart keeper pulled apart a couple weeks ago. Not sure why, Cowkid2 said, "hey this thing fell out", when we were loading up. I wasn't sure what it was until we got home. I never locked the cart into the scupper before.
The bungie pulled out:
Pop the cap off the bottom of the leg where the cart keeper is:
I used a 1/4" drill bit to make a new hole all the way through, then put the bungie through and seat it in the grove in the bottom of the plastic plug:
Pop the stainless steel pin back in from the bottom. I tapped it in with my bench vise holding the pin, and tapped it together with a dead blow:
Filled the hole with a hot glue gun, and pulled the knot down in and flush.
Push the bungie back down trough the leg, and grab it with some needle nose pliers:
Tie it up with the knot or hitch of your choosing. I used and over hand knot on the bottom and a half hitch above it. Then put the plug back in...good as or better than new.
The bungie pulled out:
Pop the cap off the bottom of the leg where the cart keeper is:
I used a 1/4" drill bit to make a new hole all the way through, then put the bungie through and seat it in the grove in the bottom of the plastic plug:
Pop the stainless steel pin back in from the bottom. I tapped it in with my bench vise holding the pin, and tapped it together with a dead blow:
Filled the hole with a hot glue gun, and pulled the knot down in and flush.
Push the bungie back down trough the leg, and grab it with some needle nose pliers:
Tie it up with the knot or hitch of your choosing. I used and over hand knot on the bottom and a half hitch above it. Then put the plug back in...good as or better than new.
Comment